EasyBend
DuoTrack is the most advanced rail bender for code 332, 250 (both codes
can be bent with base unit, if you use the associated conversion
kit). The EasyBend DuoTrack allows the simultaneous bending
of two tracks either mounted on ties or loose without ties.
In addition the bender can be applied to already laid track in order to
re-bend curves. EasyBend DuoTrak’s unique
patent pending design eases the task of bending the track to customer
specification. Features include:
Precise
parallel tracks for the entire track
section in accordance to NRMA norm
Repeatable
radius through precise adjustment
control
Can bend on
flat ground entire track sections and therefore avoids any warping of
the track found with conventional rail bender
Build-in
levels to verify correct leveling and inclines of the track
Easy to use
Save time and
avoids mistakes
The KeepParallel clamp is very useful if you want to avoid to have to
make two cuts after bending the rail.
Background:
When you bend rail the inner rail will be longer than the outer
rail. With EasyBend DuoTrak you typically bend in more than
one pass (back and forth operation) your rail. Therefore the
inner rail will longer on both side of the track and you will have to
make cuts on both ends. Especially on stainless
steel this can become expensive (two cuts and one one
reinforced Dremmel cutoff wheel is gone)
Contact current holder to
obtain unit for your use.
Be sure to contact webmaster
when some other club member
receives the unit from you.
Ride over your layout
- like a train -
and bend the track right in place.
